turnoff — Enables an instrument to turn itself off.


Enables an instrument to turn itself off.




turnoff -- this p-time statement enables an instrument to turn itself off. Whether of finite duration or held, the note currently being performed by this instrument is immediately removed from the active note list. No other notes are affected.

[Note] Note

As a rule of thumb, you should turn off instruments with a higher instrument number than the one where turnoff is called, as doing otherwise might cause initialization issues.


The following example uses the turnoff opcode. It will cause a note to terminate when a control signal passes a certain threshold (here the Nyquist frequency). It uses the file turnoff.csd.

Example 831. Example of the turnoff opcode.

See the sections Real-time Audio and Command Line Flags for more information on using command line flags.

; Select audio/midi flags here according to platform
; Audio out   Audio in
-odac           -iadc    ;;;RT audio I/O
; For Non-realtime ouput leave only the line below:
; -o turnoff.wav -W ;;; for file output any platform

; Initialize the global variables.
sr = 44100
kr = 4410
ksmps = 10
nchnls = 1

; Instrument #1.
instr 1
  k1 expon 440, p3/10,880     ; begin gliss and continue
  if k1 < sr/2  kgoto contin  ; until Nyquist detected
    turnoff  ; then quit

  a1 oscil 10000, k1, 1
  out a1


; Table #1: an ordinary sine wave.
f 1 0 32768 10 1

; Play Instrument #1 for 4 seconds.
i 1 0 4


See Also

ihold, turnoff2, turnon