tablei — Accesses table values by direct indexing with linear interpolation.


Accesses table values by direct indexing with linear interpolation.


ares tablei andx, ifn [, ixmode] [, ixoff] [, iwrap]
ires tablei indx, ifn [, ixmode] [, ixoff] [, iwrap]
kres tablei kndx, ifn [, ixmode] [, ixoff] [, iwrap]


ifn -- function table number. tablei requires the extended guard point.

ixmode (optional) -- index data mode. The default value is 0.

  • 0 = raw index

  • 1 = normalized (0 to 1)

ixoff (optional) -- amount by which index is to be offset. For a table with origin at center, use tablesize/2 (raw) or .5 (normalized). The default value is 0.

iwrap (optional) -- wraparound index flag. The default value is 0.

  • 0 = nowrap (index < 0 treated as index=0; index > tablesize sticks at index=size)

  • 1 = wraparound.


tablei is a interpolating unit in which the fractional part of index is used to interpolate between adjacent table entries. The smoothness gained by interpolation is at some small cost in execution time (see also oscili, etc.), but the interpolating and non-interpolating units are otherwise interchangeable. Note that when tablei uses a periodic index whose modulo n is less than the power of 2 table length, the interpolation process requires that there be an (n + 1)th table value that is a repeat of the 1st (see f Statement in score).


Here is an example of the tablei opcode. It uses the file tablei.csd.

Example 785. Example of the tablei opcode.

See the sections Real-time Audio and Command Line Flags for more information on using command line flags.

; Select audio/midi flags here according to platform
-odac     ;;;realtime audio out
;-iadc    ;;;uncomment -iadc if realtime audio input is needed too
; For Non-realtime ouput leave only the line below:
; -o tablei.wav -W ;;; for file output any platform

sr = 44100
ksmps = 32
nchnls = 2
0dbfs  = 1

seed 0	;generate new values every time the instr is played

instr 1

ifn = p4
isize = p5
ithresh = 0.5
itemp ftgen ifn, 0, isize, 21, 2

iwrite_value = 0
i_index = 0
    iread_value tablei i_index, ifn
    if iread_value > ithresh then
         iwrite_value = 1
         iwrite_value = -1
tableiw iwrite_value, i_index, ifn
loop_lt i_index, 1, isize, loop_start        


instr 2

ifn = p4
isize = ftlen(ifn)    
prints "Index\tValue\n"
i_index = 0
    ivalue tablei i_index, ifn
    prints "%d:\t%f\n", i_index, ivalue

  loop_lt i_index, 1, isize, loop_start		;read table 1 with our index

aout oscili .5, 100, ifn			;use table to play the polypulse
     outs   aout, aout

i 1 0 1 100 16
i 2 0 2 100

See Also

table, table3, oscil1, oscil1i, osciln

More information on this opcode: , written by Jacob Joaquin